產品標準 standard
本產品按GB12706《額定電壓35KV銅芯、鋁芯塑料絕緣電力電纜》標準生產，同時還可根據用戶需要按******電工委員會推薦標準IEC、英國標準、德國標準及美國標準生產。The product is manufactured according to the standard of GB12706、IEC.BS,DIN and ICEA upon request.
適用范圍 Applications
本產品適用于工頻額定電壓64/1KV及以下配電網或工業裝置中固定敷設之用。
The product is suitable for use in power distribution lines or fixed installations with rated power- frequency voltage up to and including 0.6/1Kv.
使用特性 Operating characteridtles
·工頻額定UO/U為0.6/1KV。
Rated power –frequency voltage UO/U為0.6/1KV。
電纜導體允許長期***高工作溫度為90℃。
Max.permissible continuous operating temperature of conductor:90℃.
短路時（***長持續時間不超過5s）電纜導體的***高溫度不超過250℃。
Max.short –circuit temperature of conductor shall not exceed 250℃(5s maximum duration ).
電纜敷設時環境溫度應不低于0℃。
The ambient temperature under installation should not below 0℃.
電纜彎曲半徑：不小于電纜外徑的15倍。
The bending radius should not less than 15 times of cable diameter.
電纜的型號 Type of cable
| 型號 Type |
名稱 Designation |
適用范圍 Application |
| YJV |
銅芯交聯聚乙烯絕緣聚氯乙烯外護套電力電纜 Copper conductor ,XLPE insulated ,PVC sheathed power cable |
室內、隧道、電纜溝內或直脈地下，能夠承受一定的機械外力和一定的拉力。 For laying indoor , in tunnel, cable French, well or direct in ground , able to bear external mechanical forces and certain pulling force. |
| YJLV |
鋁芯交聯聚乙烯絕緣聚氯乙烯護套電力電纜 Aluminum conductor ,XLPE insulated ,PVC sheathed power cable |
| YJY |
銅芯交聯聚乙烯絕緣聚乙烯外護套電力電纜 Copper conductor ,XLPE insulated ,PE sheathed power cable |
| YJLY |
鋁芯交聯聚乙烯絕緣聚乙烯護套電力電纜 Aluminum conductor ,XLPE insulated ,PE sheathed power cable | |
電纜的型號
| 型號 Type |
名稱 Designation |
適用范圍 Application |
| YJLW02-Z |
銅芯交聯聚乙烯絕緣皺紋鋁套聚氯乙烯外護套縱向阻水電力電纜 Copper conductor , XLPE insulated ,creasing-aluminum sheathed and PVC sheathed longitudinal-block-water power cable |
室內、隧道、電纜溝內或直埋地下，可在潮濕環境及地下水位較高的地方使用，能夠承受一定的機械外力和一定的拉力 For laying indoors ,in tunnel, cable French, well or direct in ground , use in the damp place and in the high water table ,able to bear external mechanical forces and certain pulling force. |
| YJLLW02-Z |
鋁芯交聯聚乙烯絕緣皺紋鋁套聚氯乙烯外護套縱向阻水電力電纜 Aluminum conductor , XLPE insulated ,creasing-aluminum sheathed and PVC sheathed longitudinal-block-water power cable |
| YJLW03-Z |
銅芯交聯聚乙烯絕緣皺紋鋁套聚乙烯外護套縱向阻水電力電纜 Copper conductor , XLPE insulated ,creasing-aluminum sheathed and PE sheathed longitudinal-block-water power cable |
| JLLW03-Z |
鋁芯交聯聚乙烯絕緣皺紋鋁套聚乙烯外護套縱向阻水電力電纜 Aluminum conductor , XLPE insulated ,creasing-aluminum sheathed and PE sheathed longitudinal-block-water power cable |
| YJV |
銅芯交聯聚乙烯絕緣聚氯乙烯外護套電力電纜 Copper conductor, XPLE insulated and PVC sheathed power cable |
室內、隧道及電纜溝內等場所，不能承受機械外力。 For laying indoors, In tunnel , cable trench,well or direct in ground,able to bear external mech- anical forces and certain pulling force. |
| YJLV |
鋁芯交聯聚乙烯絕緣聚氯乙烯外護套電力電纜 Aluminum conductor, XPLE insulated and PVC sheathed power cable |
| YJY |
銅芯交聯聚乙烯絕緣聚乙烯外護套電力電纜 Copper conductor, XPLE insulated and PE sheathed power cable |
| YJLY |
鋁芯交聯聚乙烯絕緣聚乙烯外護套電力電纜 Aluminum conductor, XPLE insulated and PE sheathed power cable | |
生產范圍Production Range of Cable
| 型號 Type |
芯數
No.of cores |
導體標稱截面
Nominal cross-section of conductor mm2 |
| 銅導體 Copper conductor |
鋁導體 Aluminum conductor |
1* |
|
YJV YJY
YJV22 YJV23 |
YJLV YJLY
YJLV22 YJLV23 |
2 |
1.5~800
2.5~800
10~800 |
YJV YJY
YJV22 YJV23
YJV32 YJV33 |
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
3 |
1.5~300
2.5~300
2.5~300
10~300 |
YJV YJY
YJV22 YJV23
YJV32 YJV33
|
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
4 |
1.5~400
2.5~400
2.5~400
10~400 |
YJV YJY
YJV22 YJV23
YJV32 YJV33
|
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
3＋1 |
1.5~400
2.5~400
2.5~400
10~400 |
YJV YJY
YJV22 YJV23
YJV32 YJV33
|
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
5 |
1.5~400
4.0~400
1.5~400
4.0~400
10~400 |
YJV YJY
YJV22 YJV23
YJV32 YJV33
|
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
4＋1 |
1.5~400
2.5~400
1.5~400
2.5~400
10~400 |
YJV YJY
YJV22 YJV23
YJV32 YJV33
|
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
3＋2 |
1.5~400
4.0~400
1.5~400
4.0~400
10~400 |
YJV YJY
YJV22 YJV23
YJV32 YJV33
|
YJLV YJLY
YJLV22 YJLV23
YJLV32 YJLV33 |
|
1.5~400
4.0~400
1.5~400
4.0~400
10~400 | |
*單芯鎧裝電纜僅用于直流系統，若用于交流系統，應采用非磁性材料鎧裝或隔磁措施。
*The armoured single-core cables are used for d.c. system only.As for a.c. system,non-magnetic armour material should be used,or a magnetic isolation shouls beapplied.
| | |
